- Problems & Solutions
- Solutions
- Soundproofing of walls
- Frameless wall cladding ZIPS Slim
Frameless wall cladding ZIPS Slim
Thickness: 37,5 mm
ΔRw ≈ 11 dB
When applied?
- When the wall on which installation is to be performed is made of 200 mm thick gas silicate blocks.
- Saves from noises of average volume - conversations, TV, barking dogs, crying children.
Overview
ZIPS Slim for inner apartment walls made of AAC/GC!
Other constructions in this section
Frameless wall cladding ZIPS III-ULTRA
Frameless wall cladding ZIPS-4
Frameless wall cladding ZIPS Vector
Frame lining using versalite vibroinsulating hang Ultrakustik Connect
Frameless wall cladding ZIPS Modul
Frameless wall cladding ZIPS Cinema
Frameless wall cladding ZIPS STS
Independent frame cladding on coupled profile 50 mm
You can calculate the approximate estimate of sound insulation in your case. To do this, it is enough to enter the surface area that is supposed to be isolated. The estimate is calculated with a 5% margin, as well as taking into account rounding to whole packages. Please note that the estimate is approximate, since it does not take into account the individual characteristics of your premises.
Show estimation for
m²
Just input your area. The estimate is recalculated automatically.
Specialized sound insulation materials:
Material
Quantity
Unit of measurement
Specialized accessories:
Material
Quantity
Unit of measurement
General construction materials:
Material
Quantity
Unit of measurement
Gypsum plasterboard
sheet 2000 х 1200 х 12,5 mm
-
pc
-
pc
- ZIPS-SLIM panels are attached to the wall only through the existing vibration units using plastic dowels.
- The ends of the sandwich-panels must adjoin the side walls and the ceiling through two layers of Ultrakustik TAPE vibration damping spacer. The tape is glued and fixed with Ultrakustik VS.
- The head of the screw should be screwed into the vibration unit no deeper than 1-2 mm from the level of the front side of the panel.
- If the panel is cut, then all available attachment points are used for installation. Cuttings less than 250 mm are not used in the installation.
- Upon completion of installation, the joints between the sandwich-panels are treated with Ultrakustik VS. The finishing layer of gypsum plasterboard sheets 12.5 mm thick is fixed to the resulting surface. Sheets must adjoin to the adjacent surfaces through 2 layers of Ultrakustik TAPE vibration insulating spacer as well.
- Excessively protruding Ultrakustik TAPE is cut flush with the finishing layer of gypsum plasterboard sheets. Seams are filled with Ultrakustik VS vibroacoustic silicone sealant.