Stretch ceiling filled with Ultrakustik GW-Eco
Thickness: 25 mm
When applied?
- For protection against the resonant effect that arises in the inter-ceiling space between the ceiling slab and the stretch ceiling canvas.
Overview
The structures of frameless soundproof linings are used in construction and renovation of buildings of any type and purpose for additional sound insulation of single-layer massive walls and ceilings. They have high values of weighted sound reduction index improvement of air noise and low level of radiated sctuctural noise.
Other constructions in this section
Frameless ceiling cladding ZIPS III-ULTRA
Frameless ceiling cladding ZIPS Vector
Frameless ceiling cladding ZIPS Modul
Frameless ceiling cladding ZIPS Cinema
Frameless ceiling cladding ZIPS 4
Frame soundproofing ceiling on hangers Ultrakustik Connect
Frame soundproofing ceiling on hangers Ultrakustik Connect (2 layers)
You can calculate the approximate estimate of sound insulation in your case. To do this, it is enough to enter the surface area that is supposed to be isolated. The estimate is calculated with a 5% margin, as well as taking into account rounding to whole packages. Please note that the estimate is approximate, since it does not take into account the individual characteristics of your premises.
Show estimation for
m²
Just input your area. The estimate is recalculated automatically.
Specialized sound insulation materials:
Material
Quantity
Unit of measurement
General construction materials:
Material
Quantity
Unit of measurement
Dowel with Rondelle washer
-
pc
Ultrakustik glue
10 l canister
-
pc
- Ultrakustik GW-Eco mats are fixed to the sub-ceiling. Ultrakustik GW-Eco is fastened to brick and concrete bases with dowels.
- To wooden bases and bases made of gypsum blocks, Ultrakustik GW-Eco is attached using washers for thermal insulation of the Rondelle type and self-tapping screws. The sheet is attached along the length with a pitch of 600 mm.
- A least 3 attachment points should be made across the canvas in each row. Sheets are joined closely without a gap.
- The cut ends are to be glued with construction adhesive tape. Sections of the shell without filler are tucked on the back side.